KSB Evamatic Box installation instructions

These operating instructions contain fundamental information and precautionary notes. It is imperative to read the manual prior to installation of unit, electrical connection and commissioning. Operating instructions relating to individual components of this unit must also be complied with.

Prior to any work carried out on the pump set, disconnect it from the all electrical supplies (including control cable) and/or remove the mains plug. The pump set must be protected against accidental start–up.

Contents
1. General.

2. Frost–proof Installation.

3. Description.
3.1 Evamatic Box single pumping station
3.2 Evamatic Box double pumping station

4. Installation of the Plastic Tank.
4.1 Floor installation
4.2 Underfloor installation

5. Installing the Pump(s) in the Tank.
5.1 Evamatic Box single pumping station
5.2 Evamatic Box double pumping station

6. Connection to Power Supply.

7. Dimensions.
7.1 Evamatic Box single pumping station
7.2 Evamatic Box double pumping station

8. Accessories.
8.1 Check valve with shut–off made of cast iron / galvanized steel
8.2 PVC check valve and PVC check valve with shut–off
8.3 Hand pump
8.4 AS 0 Alarm switchgear
8.5 Cover extension piece

9. Automatic Operating Mode.

1. General
Safety Instructions for Maintenance, Inspection and Installation Work
The entire plant must comply with the requirements of the standard EN 12050.
The operator must take care that all maintenance, inspection and installation work is done by fully qualified and authorized personnel which must carefully study these operating instructions prior to the performance of this work.
As a general rule, work on the equipment must be carried out only during standstill. Please observe all instructions set out in the chapter ”Commissioning” (see Operating instructions Pump) before returning the machine to service.
The sewage lifting unit and its components must be inspected and maintained at least once a year.
Systematically disconnect all electrical connections prior to work on the station or the pumps.
For maintenance work, the pump(s) must be taken out of the tank.

Access to the tank

The following safety instructions must be adhered to without fail before climbing into the tank!

2. Frost–proof installation

6. Connection to power supply
Single pumping stations
The single–phase pump sets are supplied complete with power supply cable and mains plug.

Double pumping stations

The three–phase pump sets do not come with a mains switch. Remove the protection on the cable end shortly before connection to power supply.
The individual cores are marked at the end of the cable.
If the cables have to be shortened, please note the markings and/or colours of the cores.

Twin pumping stations are connected in the control cabinet (switchgear).

8. Accessories.

9. Automatic operating mode

Latest news
Drainstore.com sponsored powerboat wins championship in Isle of Man. Mon 15/09/2008 The Honda Formula 4-Stroke Powerboat race series made a spectacular end to the 2008 race season on Sunday 14th September in Douglas Bay as... Drainstore sponsored powerboat in action. Liverpool August 2008 Mon 01/09/2008 Cockman can clinch title at Isle of Man grand prix Taken from Exeter press Thursday, September 04, 2008 EXMOUTH'S Jak Cockman is on course to... Latest news on the Drainstore.com sponsored Honda Powerboat Fri 13/06/2008 New 2008 Buildbase boat debut in Torquay After a disappointing 2007 season suffering both structural... Drainstore.com achieves runner up position in Derbyshire Chamber Small Business of the Year Awards Thu 11/01/2007 Directors Paul and Kevin Marshall were delighted to have been awarded the runners up prize at the Derbyshire Chamber Small Business of The Year... Drainstore.com achieves runner up position in Derbyshire Chamber Small Business of the Year Awards Mon 27/03/2006 Directors Paul and Kevin Marshall were delighted to have been awarded the runners up prize at the Derbyshire Chamber Small Business of The Year...